Chrysler Stratus RHD 1997 Interactive Electronic Service Manual page 990

THROTTLE BODY SUPPORT BRACKET BOLT THROTTLE POSITION SENSOR
JA
REMOVAL AND INSTALLATION (Continued)
Fig. 26 Intake Manifold Sensors and LeftManifold
Support Bolt
(8) Release snaps holding air cleaner housing
cover to housing.
(9) Remove air cleaner cover and inlet hoses from
engine.
(10) Unplug TPS and idle air control motor con-
nectors (Fig. 27) and (Fig. 28).
Fig. 27 Throttle Position Sensor
(11) Squeeze retainer tab on throttle cable and
slide cable out of bracket (Fig. 29).
(12) Slide Speed control cable out of bracket, if
equipped (Fig. 29).
(13) Remove EGR tube from intake manifold (Fig.
30).
(14) Remove plenum support bracket bolt located
rearward of EGR tube (Fig. 30).
(15) Remove 7 bolts holding upper intake plenum
and remove plenum (Fig. 23).
(16) Disconnect electrical connectors from fuel
injectors.
(17) Remove 4 bolts holding fuel rail (Fig. 31).
MAP SENSOR PERATURE INTAKE AIR SEN- TEM- SOR POSITION SEN- THROTTLE CONTROL SPEED CABLE SOR EGR
EXHAUST SYSTEM AND INTAKE MANIFOLD
Fig. 28 Idle Air Control Motor
Fig. 29 Throttle Cable Attachment
Fig. 30 EGR Tube and Right Manifold SupportBolt
(18) Lift fuel rail off engine. There are spacers
under each fuel rail bolt (Fig. 32).
(19) Remove lower intake manifold attaching bolts.
Remove intake manifold.
BOLTS TUBE EGR TUBE THROTTLEBODY IDLE SUPPORT THROTTLE CABLE
RELEASE TANG
AIR CONTROL BRACKET MOTOR BOLT
11 - 13