Chrysler Stratus RHD 1997 Interactive Electronic Service Manual page 49

SPECIAL TOOL 6756 SPECIAL TOOL C-4212-F FRONT ISOLATOR BUSHING LOWER CONTROL ARM LOWER CONTROL ARM
2 - 38 SUSPENSION
DISASSEMBLY AND ASSEMBLY (Continued)
control arm bushing hole, with the void in rubber
portion of bushing facing away from ball joint (Fig.
102).
Fig. 102 Correctly Positioned Rear IsolatorBushing
In Control Arm
(2) Mount Bushing Installer, Special Tool 6760 on
screw portion of Remover/Installer Special Tool
C-4212-F (Fig. 103).
(3) Install Special Tools assembled for installation
of rear isolator bushing into lower control arm on the
lower control arm. Be sure Special Tool 6756 is
square on lower control arm and Special Tool 6760 is
positioned correctly on isolator bushing (Fig. 103).
Fig. 103 Installing Rear Bushing In LowerControl
(4) Tighten screw on Remover/Installer Special
Tool C-4212-F pressing rear bushing into lower con-
trol arm. Continue pressing rear bushing into lower
control arm until bushing is sitting flush on the
machined surface (Fig. 103) of the lower control arm.
This will correctly position rear bushing in lower con-
trol arm.
VOID IN BUSHING IN THIS REAR ISOLATOR BUSHING REAR BUSHING SPECIAL MACHINED SURFACE ON DIRECTION LOWER CONTROL ARM MACHINED SURFACE
Arm
TOOL 6760 LOWER CONTROL ARM SPECIAL TOOL 6877
(5) Install lower control arm assembly back on
vehicle. See Lower Control Arm Installation in this
section of the service manual for the required instal-
lation procedure.
CONTROL ARM CLEVIS BUSHING
To perform removal and replacement of the lower
control arm clevis bushing, the lower control arm
must be removed from the vehicle.
DISASSEMBLE
(1) Remove lower control arm assembly from vehi-
cle. See Lower Control Arm Removal in this section
of the service manual for the required removal proce-
dure.
(2) Install Bushing Remover, Special Tool 6877 and
Bushing Receiver, Special Tool 6876 on Special Tool
C-4212-F.
(3) Install lower control arm on Special Tools
assembled for removal of the clevis isolator bushing.
Be sure Special Tool 6876 is square on lower control
arm and Special Tool 6877 is positioned correctly on
clevis bushing (Fig. 104).
Fig. 104 Removing Clevis Bushing From
(4) Tighten screw on Remover/Installer Special
Tool C-4212-F to press clevis bushing out of lower
control arm.
ASSEMBLE
(1) Start clevis bushing into lower control arm by
hand, making sure it is square with its mount-
ing hole in the lower control arm. Bushing is to
be installed in lower control arm from the machined
surface side of lower control arm bushing hole.
(2) Mount Bushing Installer, Special Tool 6877 on
screw portion of Remover/Installer Special Tool
C-4212-F as shown in (Fig. 105).
(3) Install the assembled special tools for installing
the clevis bushing into the lower control arm, on the
LowerControl Arm
SPECIAL TOOL 6876 SPECIAL TOOL C-4212-F
JA