Chrysler Stratus RHD 1997 Interactive Electronic Service Manual page 398

JA
REMOVAL AND INSTALLATION (Continued)
HEADLAMP LEVELING SWITCH
REMOVAL
(1) Disconnect and isolate the battery negative
cable.
(2) Using a trim stick or other suitable wide flat
bladed tool, pry gently around the edges of the head-
lamp leveling switch (Fig. 7).
Fig. 7 Headlamp Leveling Switch
(3) Pull the headlamp leveling switch out from the
instrument cluster hood far enough to disengage the
wiring connector.
(4) Remove the switch from the instrument cluster
hood.
INSTALLATION
Reverse the preceding operation.
INSTRUMENT PANEL AND GAUGE
SPEEDOMETER/TACHOMETER AND ODOMETER
TRANSMISSION RANGE INDICATOR
REMOVAL
(1) Remove mask/lens
remove mask/lens.
(2) Disconnect odometer/transmission range indi-
cator connector from the printed circuit board.
(3) Remove screws attaching speedometer/tachom-
eter to housing and remove.
(4) Remove screws attaching from the back of
speedometer and remove the odometer/transmission
range indicator display (Fig. 8).
INSTALLATION
For installation, reverse the above procedures.
Fig. 8 Odometer/Transmission Range Indicator
8E - 3
retaining screws and