Chrysler Stratus RHD 1997 Interactive Electronic Service Manual page 869

WHEELHOUSE SPECIAL TOOL 1026 SPLASH SHIELD PUSH-IN FASTENER NUT-SNAP
9 - 32 2.0L SOHC ENGINE
REMOVAL AND INSTALLATION (Continued)
REMOVAL—TIMING BELT
(1) Remove accessory drive belts. Refer to Group 7,
Cooling System for procedure outlined in that sec-
tion.
(2) Raise vehicle on a hoist and remove right inner
splash shield (Fig. 54).
Fig. 54 Right Inner Splash Shield
(3) Remove crankshaft
damper using the large side of Special Tool 1026 and
insert 6827-A (Fig. 55).
Fig. 55 Crankshaft Damper—Removal
FENDER SPECIAL ACCESSORY 6827–A INSERT BELT SPLASH SHIELD PUSH-IN FAS- TOOL TENER FASCIA DRIVE
damper bolt. Remove
ACCESS PLUG ENGINE MOUNT BRACKET- TO-ENGINE FASTENERS FASTENERS
(4) Lower vehicle and place a jack under engine.
(5) Remove right engine mount. Refer to procedure
outlined in this section.
(6) Remove right engine mount bracket (Fig. 56).
(7) Remove front timing belt cover (Fig. 57).
CAUTION: Align camshaft and crankshaft timing
marks before removing the timing belt.
(8) Loosen timing belt tensioner fasteners (Fig. 58)
and remove timing belt and tensioner.
Fig. 56 Right Engine Mount Bracket—Typical
Fig. 57 Timing Belt Cover
INDICATES CLIP LOCATION RETAINING
JA