Chrysler Stratus RHD 1997 Interactive Electronic Service Manual page 48

SPECIAL SPECIAL TOOL MB-990799 SPECIAL TOOL 6876 ISOLATOR C-4212-F SPECIAL TOOL TOOL BUSH- ING C-4212-F MACHINED SURFACE SIDE OF LOWER CONTROL ARM
JA
DISASSEMBLY AND ASSEMBLY (Continued)
Fig. 99 Removing Front Bushing From
LowerControl Arm
(4) Tighten screw on Remover/Installer Special
Tool C-4212-F to press front bushing out of lower
control arm.
ASSEMBLY
(1) Mount Bushing Installer, Special Tool 6876 on
screw portion of Remover/Installer Special Tool
C-4212-F (Fig. 100).
(2) Start front bushing into lower control arm by
hand, making sure it is square with its mount-
ing hole in the lower control arm. Bushing is to
be installed in lower control arm from the machined
surface side of lower control arm bushing hole.
(3) Install lower control arm on Special Tools
assembled for installation of front isolator bushing
into lower control arm (Fig. 100). Be sure Special
Tool 6758 is square on lower control arm and Special
Tool 6876 is positioned correctly on isolator bushing.
Fig. 100 Installing Front Bushing In LowerControl
LOWER CONTROL ARM FRONT ISOLATOR BUSHING SPECIAL TOOL 6602-5 SPECIAL TOOL 6758
Arm
SPECIAL TOOL C-4366-2 SPECIAL TOOL C-4212-F
(4) Tighten screw on Remover/Installer Special
Tool C-4212-F pressing front bushing into lower con-
trol arm. Continue pressing front bushing into lower
control arm until bushing is sitting flush on the
machined surface of the lower control arm. This will
correctly position front bushing in lower control arm.
(5) Install lower control arm assembly back on
vehicle. See Lower Control Arm Installation in this
section of the service manual for the required instal-
lation procedure.
LOWER CONTROL ARM REAR ISOLATOR BUSHING
To perform removal and replacement of the lower
control arm isolator bushings, the lower control arm
must be removed from the vehicle.
DISASSEMBLY
(1) Remove lower control arm assembly from vehi-
cle. See Lower Control Arm Removal in this section
of the service manual for the required removal proce-
dure.
(2) Install Bushing Remover, Special Tool 6756 and
Bushing Receiver, Special Tool C-4366-2 on Special
Tool C-4212-F (Fig. 101).
(3) Install Special Tools assembled for removal of
the rear isolator bushing on the lower control arm.
Be sure Special Tool C-4366-2 is square on lower con-
trol arm and Special Tool 6756 is positioned correctly
on isolator bushing (Fig. 101).
Fig. 101 Removing Lower Control Arm Rear
(4) Tighten screw on Remover/Installer Special
Tool C-4212-F to press rear bushing out of lower con-
trol arm.
ASSEMBLY
(1) Start rear bushing into lower control arm by
hand, making sure it is square with its mount-
ing hole in the lower control arm. Bushing is to
be installed from the machined surface side of lower
LOWER CONTROL ARM SPECIAL TOOL 6756
SUSPENSION
Bushing
2 - 37