Chrysler Stratus RHD 1997 Interactive Electronic Service Manual page 17

2 - 6 SUSPENSION
SERVICE PROCEDURES (Continued)
adjust Camber and Toe until both are at their pre-
ferred specifications.
(6) While holding adjustment screws from turning,
use a crow foot and torque wrench, and tighten all
lateral link adjusting screw jam nuts to a torque of
65 N·m (48 ft. lbs.). This will securely hold adjusting
screws from turning.
CAUTION: Do not twist front inner tie rod to steer-
ing gear rubber boots during front wheel Toe
adjustment.
(7) Loosen front inner to outer tie rod end jam
nuts (Fig. 4). Grasp inner tie rods at serrations (Fig.
4) and rotate inner tie rods of steering gear to set
front Toe to the preferred Toe specification. See
Alignment Specifications in this group of the service
manual for preferred specification
OUTER TIE ROD KNUCKLE STEERING
.
Fig. 4 Inner To Outer Tie Rod Jam Nut
(8) Tighten tie rod locknuts (Fig. 4) to 61 N·m (45
ft. lbs.) torque.
(9) Adjust steering gear to tie rod boots (Fig. 4) at
inner tie rod.
(10) Remove steering wheel clamp.
ADJUSTMENT SERRATIONS JAM NUT INNER
STEERING GEAR
BOOTS
ROD TIE
JA