Chrysler Stratus RHD 1997 Interactive Electronic Service Manual page 43

DISC BRAKE CALI- DISC BRAKE CALI- PER PER ASSEMBLY WIRE HANGER ASSEMBLY STEERING (STORED) KNUCKLE BRAKING DISC
2 - 32 SUSPENSION
REMOVAL AND INSTALLATION (Continued)
(5) Support brake caliper/adapter assembly using a
wire hook and not by hydraulic hose (Fig. 80).
Fig. 80 Supporting Brake Caliper
(6) Remove braking disc from front hub (Fig. 81).
Fig. 81 Removing/Installing Front BrakingDisc
(7) Install a lug nut on wheel stud to be removed
from hub and bearing assembly, (Fig. 82) so threads
on stud are even with end of lug nut. Rotate hub so
stud requiring removal is aligned with notch cast
into front of steering knuckle. Install Remover, Spe-
cial Tool C-4150 on hub and bearing assembly flange
and wheel stud (Fig. 82).
(8) Tighten down on special tool, this will push the
wheel stud out of the hub and bearing flange.
INSTALL
(1) Install replacement wheel stud into flange of
hub and bearing assembly. Install washers on wheel
stud, then install a wheel lug nut on stud with flat
side of lug nut against washers (Fig. 83).
(2) Tighten the wheel lug nut, pulling the wheel
stud into the flange of the hub and bearing assembly.
UPPER CONTROL ARM STEERING KNUCKLE
ABS SPEED SEN-
ROTOR STEERING KNUCKLE WHEEL STUD FRONT HUB
SOR CABLE
Fig. 82 Removing Wheel Stud From Hub
Fig. 83 Installing Wheel Stud Into Hub
When the head of the stud is fully seated against the
bearing flange, remove lug nut and washers from
wheel stud.
(3) Install braking disk back on front hub (Fig.
81).
(4) Install disc brake caliper assembly on steering
knuckle. Caliper is installed by first sliding top of
caliper under top abutment on steering knuckle.
Then installing bottom of caliper against bottom
abutment of steering knuckle (Fig. 79).
(5) Install disc brake caliper assembly to steering
knuckle attaching bolts (Fig. 78) and torque to 31
N·m (23 ft. lbs.).
(6) Install front wheel and tire assembly. Install
front wheel lug nuts and torque to 129 N·m (95
ft.lbs.).
(7) Lower vehicle.
WASHERS STEERING KNUCKLE LUG NUT FRONT HUB SPECIAL
AndBearing
WHEEL C-4150A TOOL NUT LUG
JA