Chrysler Stratus RHD 1997 Interactive Electronic Service Manual page 148

PARK BRAKE MECHANISM MOUNTING BOLTS MOUNTING BOLTS BRACKET
JA
REMOVAL AND INSTALLATION (Continued)
(13) Remove the 4 bolts (Fig. 130) attaching the
park brake mechanism bracket.
Fig. 130 Park Brake Lever Bracket Mounting
(14) Remove the park brake mechanism from the
vehicle.
INSTALL
(1) Place the park brake mechanism on the console
bracket. Install the 4 bolts (Fig. 130) mounting the
park brake mechanism to the console bracket.
Tighten the 4 mounting bolts to a torque of 28 N·m
(250 in. lbs.).
(2) Install the wiring harness (Fig. 129) on the
park brake mechanism bracket.
(3) Install the electrical connector on the ground
switch of the park brake lever mechanism (Fig. 128).
CAUTION: A new cable tension equalizer must be
installed when replacing the park brake mechanism.
The new cable tension equalizer is required to cor-
rectly adjust park brake cable tension after install-
ing park brake mechanism.
PARK BRAKE CABLE TEN- PARKING REAR PARK BRAKE CABLES REAR PARK BRAKE CABLES PARK BRAKE LEVER OUT- PARK BRAKE CABLE TEN- PARK BRAKE MECHANISM PARK BRAKE MECHANISM CABLE RETAINING CLIP NISM OUTPUT CABLE PARK BRAKE LEVER SION EQUALIZER SION EQUALIZER BRAKE PUT CABLE MECHA-
(4) Install a NEW park brake cable tension equal-
izer on the park brake lever output cable and rear
park brake cables (Fig. 131).
Fig. 131 Park Brake Cable Tension Equalizer
CAUTION: A new park brake lever output cable
retainer must be used when installing output cable
on cable tension equalizer. Cable retainer usage is
required to ensure output cable can not separate
from tension equalizer.
(5) Install a new park brake lever output cable to
tension equalizer retaining clip (Fig. 132) on tension
equalizer. The cable retainer (Fig. 132) must be
closed and securely latched.
Fig. 132 Cable Retainer Installed On
TensionEqualizer
BRAKES 5 - 53