Chrysler Stratus RHD 1997 Interactive Electronic Service Manual page 944

SUPPORT REAR STRUT BRACKET SUPPORT TRANSMISSION FWD BRACKET MODELS) (SOME SUP- PORT STRUT STRUT
JA
REMOVAL AND INSTALLATION (Continued)
Fig. 25 Engine Support Module
(6) Tighten thru bolt at front mount see (Fig. 27)
tighten to 61 N·m (45 ft. lbs.).
Fig. 26 Engine Mounting—Rear 2.4 and2.5L
Fig. 27 Engine Mounting—Front 2.5L
REAR 61 N·m (45 ft. lbs.) 110 N·m (80 ft. lbs.) DAMPER LOWER ENGINE MOUNT ENGINE SUPPORT MODULE TORQUE 61 N·m (45 ft. lbs.) REAR TORQUE BRACKET TORQUE FRONT RADIATOR WEIGHT CLIP STARTER WIRING TORQUE FRONT BRACKET MODELS) ENGINE ENGINE) (SOME ENGINE PORT
110 N·m (80 ft. lbs.)
33 N·m (24 ft. lbs.)
MOUNT SUP- (2.5L RIGHT FRAME RAIL45 FT. LBS (61 N·m) ENGINE ASSEMBLY SUPPORT
ENGINE MOUNT—RIGHT/ENGINE SUPPORT
BRACKET
NOTE: The right side engine mount is a Hydro-
Mount and may show surface cracks this will not
effect it's performance and should not be replaced.
Only replace the Hydro-Mount when it's leaking
fluid.
(1) Raise vehicle on a hoist and remove inner
splash. Remove the right engine support assembly
vertical fasteners from frame rail (Fig. 28).
(2) Lower vehicle. Remove the load on the engine
motor mounts by carefully supporting the engine
assembly with a floor jack.
(3) Remove the three bolts attaching the engine
support assembly to the engine bracket.
(4) Move the air conditioning dryer aside.
(5) Remove coolant recovery system tank. Refer to
Group 7, Cooling System for procedure.
(6) Remove right engine support.
(7) Remove the three bolts attaching the engine
support bracket to the cylinder block.
NOTE: If centering or adjusting the engine/trans-
mission assembly is needed refer to Adjustments,
in this section.
(8) Reverse removal procedure for installation.
Refer to (Fig. 28) for bolt tightening specifications.
Fig. 28 Engine Mounting—Right Side2.5L
LEFT SIDE MOUNT
NOTE: If centering or adjusting the engine/trans-
mission assembly is needed refer to Adjustments,
in this section.
The left side engine mount is a Hydro-Mount and
may show surface cracks this will not effect it's
performance and should not be replaced. Only
replace the Hydro-Mount when it's leaking fluid.
FWD
2.5L ENGINE 9 - 107