Sensor-2.5L; Intake Air Temperature Sensor - Chrysler Stratus RHD 1997 Interactive Electronic Service Manual

TEMPERATURE INTAKE INTAKE MANIFOLD SENSOR AIR ENGINE COOLANT TEMPER- MAP SENSOR
8D - 26 IGNITION SYSTEM
REMOVAL AND INSTALLATION (Continued)
INSTALLATION
2.5L
(1) Install ECT sensor. Tighten sensor to 7 N·m
(60 in. lbs.) torque.
(2) Attach electrical connector to sensor.
(3) Fill cooling system. Refer to Group 7, Cooling
System.
Fig. 57 Engine Coolant Temperature Sensor—
2.5LEngine

INTAKE AIR TEMPERATURE SENSOR

The intake air temperature sensor threads into the
intake manifold plenum (Fig. 58) or (Fig. 59).
REMOVAL
(1) Remove electrical connector from sensor.
(2) Remove sensor.
INSTALLATION
(1) Install sensor. Tighten sensor to 28 N·m (20 ft.
lbs.) torque.
(2) Attach electrical connector to sensor.
Fig. 58 Intake Air Temperature Sensor andMAP
Sensor—2.4L
ATURE SENSOR THROTTLE BODY
AIR INLET
TUBE
COOLANT FILL
NECK
Fig. 59 Intake Air TemperatureSensor and MAP
MAP/IAT SENSOR—SOHC
Refer to Group 14, Fuel Injection Section for
Removal/Installation.
MANIFOLD ABSOLUTE PRESSURE (MAP)
SENSOR—2.4L
The MAP sensor attaches to the intake manifold
plenum (Fig. 58)
REMOVAL
(1) Disconnect the electrical connector from the
MAP sensor.
(2) Remove sensor mounting screws.
(3) Remove sensor.
INSTALLATION
(1) Insert sensor into intake manifold while mak-
ing sure not to damage O-ring seal.
(2) Tighten mounting screws to 2 N·m (20 in. lbs)
torque.
(3) Attach electrical connector to sensor.
MANIFOLD ABSOLUTE PRESSURE (MAP)
SENSOR—2.5L
REMOVAL
(1) Remove mounting screws from sensor (Fig. 59).
(2) Unplug harness connector and remove sensor.
INSTALLATION
(1) Reverse the above procedure for installation.
THROTTLE POSITION SENSOR
Refer to Group 14, Fuel Injection Section, for
Removal/Installation.
MAP SEN- SOR PERATURE SENSOR INTAKE
Sensor—2.5L
AIR TEM-
JA