Installation; Crankshaft Position Sensor Description - Chrysler 300M Service Manual

14 - 22 FUEL INJECTION
ACCELERATOR PEDAL (Continued)
Fig. 2 RETAINER CLIP
(3) Working from the passenger compartment,
remove nuts from accelerator pedal base (Fig. 3).
Remove pedal and base from vehicle.
Fig. 3 ACCELERATOR PEDAL
1 - MOUNTING NUTS
2 - ACCELERATOR PEDAL

INSTALLATION

(1) Position accelerator pedal assembly over studs
onto dash panel. Ensure carpet and insulation are
trapped between the lip of the pedal base and the
floor plan (Fig. 4). Install mounting nuts and tighten
to 12 N·m (105 in. lbs.) torque.
(2) From inside the vehicle, hold up the pedal and
install the throttle cable and cable retainer in the
upper end of the pedal shaft.
(3) From the engine compartment, hold the throt-
tle body lever in the wide open position and install
the throttle cable.
Fig. 4 CARPET AND INSULATION PLACEMENT
1 - PEDAL BASE
2 - CARPET
3 - INSULATION
4 - FLOOR PAN
CRANKSHAFT POSITION
SENSOR
DESCRIPTION
The crankshaft sensor is located on the passengers
side of the transmission housing, above the differen-
tial housing (Fig. 5). The bottom of the sensor is posi-
tioned next to the drive plate.
The sensor is a hall effect device combined with an
internal magnet. It is also sensitive to steel within a
certain distance from it.
Fig. 5 CRANKSHAFT POSITION SENSOR
1 - CRANKSHAFT POSITION SENSOR
LH