Chrysler Stratus RHD 1997 Interactive Electronic Service Manual page 517

8U - 2 CHIME WARNING/REMINDER SYSTEM
DIAGNOSIS AND TESTING
CHIME CONDITIONS
NO TONE WHEN IGNITION SWITCH IS
TURNED ON AND DRIVERS SEAT BELT IS
UNBUCKLED AND FULLY RETRACTED
(1) Check driver's seat belt retractor switch for a
ground when belt is retracted.
(2) Use scan tool to perform CCD diagnostics on
Body Control Module for battery, ignition and seat
belt switch inputs.
(3) Use scan tool to perform actuator diagnostics
on Body Control Module Chime.
(4) Check for tone in any other function.
(5) Remove Body Control Module from Junction
Block. Check for battery voltage at terminal JB-12
and ignition feed at terminal JB-6 of Body Control
Module (Fig. 2). Refer to Group 8W, Wiring Diagrams
for terminal location.
(6) If voltage not OK, repair as necessary.
Fig. 2 Junction Block Connector to the BCM
NO FASTEN SEAT BELT LAMP WHEN
IGNITION SWITCH IS TURNED ON
(1) Use scan tool to perform CCD diagnostics on
Body Control Module for battery and ignition switch
inputs.
(2) Check for burned out bulb.
(3) Using the scan tool, do the actuator test on
cluster. Refer to proper Body Diagnostic Manual.
(4) Remove Body Control Module from Junction
Block. Check for battery voltage at terminal JB-12
and ignition feed at terminal JB-6 of Body Control
Module. Refer to Group 8W, Wiring Diagrams for ter-
minal location.
(5) If voltage not OK, repair as necessary.
FASTEN SEAT BELT LAMP OR TONE
CONTINUE FOR MORE THAN 10 SECONDS
AFTER SEAT BELTS ARE FASTENED AND
IGNITION ON
NOTE: On vehicles so equipped no audible chime
tone will sound or the seat belt indicator lamp will
remain on continuously anytime the ignition switch
is on and the driver is not wearing the seat belt.
(1) Use scan tool to perform CCD diagnostics on
Body Control Module for battery and ignition switch
input.
(2) Inspect Body Control Module connectors and
wires for proper connection.
NO TONE OR DOOR INDICATED IN PLACE OF
ODOMETER WHEN A DOOR IS AJAR AND
VEHICLE BEGINS MOVING
The vehicle must be moving for the chime to occur.
However the door indicator will come ON regardless
of the vehicle movement. The CCD bus, Transmission
Control Module (TCM) and Powertrain Control Mod-
ule (PCM) must be operational.
(1) Check all door jamb switches.
(2) Use scan tool to perform CCD diagnostics on
Body Control Module for battery and ignition switch
input
(3) Inspect Body Control Module connectors and
wires for proper connection.
(4) Remove Body Control Module from Junction
Block. Check for battery voltage at terminal JB-12
and ignition feed at terminal JB-6 of Body Control
Module. Refer to Group 8W, Wiring Diagrams for the
location of the terminals.
(5) If voltage not OK, repair as necessary.
NO TONE WHEN HEADLAMPS ARE ON,
IGNITION SWITCH IS OFF AND DRIVER'S
DOOR IS OPEN.
(1) Check left door jamb switch for good ground
when driver's door is open.
(2) Use scan tool to perform CCD diagnostics on
Body Control Module for battery, ignition switch
input, headlamp and driver's door input and Chime
Output Test.
(3) Check headlamp switch.
(4) Inspect Body Control Module connectors and
wires for proper connection.
(5) Remove Body Control Module from Junction
Block. Check for battery voltage at terminal JB-12
and ignition feed at terminal JB-6 of Body Control
JA