Chrysler Stratus RHD 1997 Interactive Electronic Service Manual page 505

8R - 2 POWER SEATS
DIAGNOSIS AND TESTING (Continued)
SEAT MOTOR SWITCH
(1) Remove switch from mounting position.
(2) Using an ohmmeter, perform the Switch Conti-
nuity Tests below and refer to (Fig. 2) for Pin loca-
tions. If there is no continuity at any of the switch
positions, replace switch.
SWITCH CONTINUITY TEST
SWITCH POSITION
OFF
VERTICAL UP
VERTICAL DOWN
HORIZONTAL AFT
HORIZONTAL FORWARD
FRONT TILT UP
FRONT TILT DOWN
REAR TILT UP
VOLTAGE
The following test will determine whether or not
voltage is continuous through the body harness to
the switch.
(1) Remove power seat switch from mounting posi-
tion and disconnect switch from wiring harness.
(2) Connect one lead of test light to Pin B of the
ground terminal, and touch other test light lead to
Pin A.
(3) If test light comes on, harness to switch is
good. If test light does not come on, perform circuit
breaker test.
CONTINUITY
BETWEEN
B-N, B-J, B-M,
B-E, B-K, B-L
B-M, B-E, A-N,
A-J
B-N, B-J, A-M,
A-E
REMOVAL AND INSTALLATION
B-K, A-L
B-L, S-K
SEAT ASSEMBLY
S-J, B-E
A-E, B-J
Removal procedures.
A-N, B-N
SEAT TRACK
Removal procedures.
SEAT SWITCH
REMOVAL
frame.
sheild.
INSTALLATION
Fig. 2 Power Seat Switch
Refer to Group 23 Body, for Power Front Seat
Refer to Group 23 Body, for Power Seat Adjuster
(1) Remove lower recliner handle.
(2) Remove screws holding seat side sheild to seat
(3) Disconnect wiring from switch.
(4) Remove screws attaching switch to seat side
(5) Remove switch.
For installation, reverse the above procedure.
JA