Chrysler Stratus RHD 1997 Interactive Electronic Service Manual page 268

CRANKSHAFT SUPPORT POWER LOCK NUT BRACKET DAMPER STEERING PUMP
JA
REMOVAL AND INSTALLATION (Continued)
ACCESSORY DRIVE BELTS—2.0/2.4L ENGINES
AIR CONDITIONING COMPRESSOR AND
GENERATOR BELT
Accessory Drive Belt System—AllEngines
(1) Loosen T-Bolt locking nut A and pivot bolt B to
remove and install Poly V belt and/or adjust belt ten-
sion (Fig. 39).
(2) Tighten adjusting bolt to adjust belt tension to
specification shown in belt tension chart (Fig. 43).
(3) Tighten T-Bolt locking nut A and pivot bolt B to
54 N·m (40 ft. lbs.) (Fig. 39).
Fig. 39 Air Conditioning Compressor and
GeneratorBelt Adjustment
AIR CONDITIONING COMPRESSOR ADJUSTING BOLT GENERATOR IDLER PIVOT IDLER BOLT LOCKING BOLT LOCKING BOLT PIVOT BOLT
POWER STEERING PUMP BELT
(1) From the top of the vehicle loosen pivot bolt C.
(2) From under the vehicle loosen locking bolts D
and E (Fig. 40).
Fig. 40 Power Steering Belt Adjustment
(3) Install the belt. Adjust belt tension with 1/2 in.
breaker bar installed in adjusting bracket. See ten-
sion specification in chart (Fig. 43).
(4) Tighten locking bolt D to 54 N·m (40 ft. lbs.)
(Fig. 40).
(5) Tighten locking bolt E and the pivot bolt C to
54 N·m (40 ft. lbs.)
1/2 SQUARE OPENING
COOLING SYSTEM
INCH
7 - 29