Table of Contents
Advertisement
TRANSMISSION
VEHICLE THEFT SECURITY
INDICATOR CONNECTOR
*ILLUMINATION LAMP
RETAINING SCREWS
CHARGING SYSTEM
MIL/CHECK ENGINE
OIL PRESSURE
SYSTEM LED
RIGHT TURN
HIGH BEAM
LEFT TURN
SEAT BELT
FOG LAMP
NOT USED
LOW FUEL
NOT USED
VTSS LED
AIR BAG
HI TEMP
CRUISE
RANGE
BRAKE
ABS
JA
REMOVAL AND INSTALLATION (Continued)
(3) Remove nine printed circuit board attaching
screws and remove. There are two screws located at
the base of each connector (Fig. 9).
INSTALLATION
For installation, reverse the above procedures.
Fig. 9 Printed Circuit Board
COMPASS/TEMPERATURE MINI-TRIP COMPUTER
MODULE
REMOVAL
(1) Disconnect the battery negative cable.
(2) Remove the Cluster Hood. Refer to Cluster
Hood removal procedure.
(3) With the cluster hood removed remove the four
screws attaching the mini computer (Fig. 10).
REMOVE SCREWS
INSTRUMENT PANEL AND SYSTEMS
Fig. 8 Lamp Location
(4) Remove CMTC from console.
INSTALLATION
For installation, reverse the above procedures.
CUBBY BIN/LAMP
REMOVAL
(1) Remove center bezel.
(2) Remove instrument cluster hood screws.
(a) Remove two screws adjacent radio.
(b) Remove screw below HVAC control in the
center.
(c) Remove screw at left end of panel.
(d) Flex instrument cluster hood slightly to give
access to the cubby bin screws.
Fig. 10 CMTC Module
8E - 7
Advertisement
Chapters
Table of Contents
