Chrysler Stratus RHD 1997 Interactive Electronic Service Manual page 394

JA
REMOVAL AND INSTALLATION (Continued)
MASK/LENS
REMOVAL
Remove mask/lens retaining screws and remove
mask/lens (Fig. 11).
INSTALLATION
For installation, reverse the above procedures.
ODOMETER/TRANSMISSION RANGE INDICATOR
REMOVAL
(1) Remove speedometer/tachometer,
Speedometer/Tachometer and Odometer Transmis-
sion Range Indicator Removal and Installation
(2) Remove screws attaching from the back of
speedometer and remove the odometer/transmission
range indicator display (Fig. 18).
INSTALLATION
For installation, reverse the above procedures.
POWER OUTLET
REMOVAL
(1) Remove cubby bin.
(2) Disconnect the two power outlet wiring connec-
tors from power outlet. Unscrew shell and clamp
assembly to replace power outlet.
INSTALLATION
For installation, reverse the above procedures. The
clamp has a locating feature. The cubby bin must
engage the console at its forward edge prior to
installing the mounting screws.
RADIO
For Radio removal procedures, Refer to Group 8F,
Audio Systems.
RIGHT UNDER INSTRUMENT PANEL SILENCER/
DUCT
REMOVAL
(1) Remove push-in fastener under right end of
instrument panel.
(2) Maneuver part off center floor distribution duct
to remove.
INSTRUMENT PANEL AND SYSTEMS
INSTALLATION
For installation, reverse the above procedures.
SPEEDOMETER/TACHOMETER AND ODOMETER
TRANSMISSION RANGE INDICATOR
REMOVAL
(1) Remove
remove mask/lens (Fig. 11).
(2) Disconnect odometer/transmission range indi-
cator connector from the printed circuit board (Fig.
12).
refer to
(3) Remove screws attaching speedometer/tachom-
eter to housing and remove (Fig. 13).
(4) Remove screws attaching from the back of
speedometer and remove the odometer/transmission
range indicator display (Fig. 18).
INSTALLATION
For installation, reverse the above procedures.
Fig. 18 Odometer/Transmission Range Indicator
VEHICLE THEFT SECURITY SYSTEM LED
REMOVAL
(1) Disconnect Vehicle Theft Security System LED
socket assembly indicator from the printed circuit
board (Fig. 8).
(2) Rotate LED socket counter clockwise and
remove from printed circuit board.
INSTALLATION
For installation, reverse the above procedures.
MOUNTING SCREWS
mask/lens retaining
8E - 13
screws and