Chrysler Stratus RHD 1997 Interactive Electronic Service Manual page 698

JA
DESCRIPTION AND OPERATION (Continued)
Circuit X52 is the feed for the right rear speaker to
the power amplifier. Circuit X58 is the return from
the amplifier to the radio.
Circuits X84 and X86 supply power and ground for
the right front instrument panel speaker.
Circuits X83 and X81 supply power and ground for
the left front instrument panel speaker.
Circuits X87 and X85 supply power and ground for
the left front door speaker.
Circuits X82 and X80 supply power and ground for
the right front door speaker.
Circuits X91, X93, X95, and X97 supply power and
ground for the left rear speaker.
Circuits X92, X94, X96, and X98 supply power and
ground for the left rear speaker.
POWER ANTENNA
The power antenna is used on the premium sys-
tems only. Battery feed for the antenna is provided
from two different circuits.
One is the M1 circuit. The M1 circuit is used to
supply power to the Body Control Module (BCM),
Power Mirrors, and the Power Door Locks. This fuse
is also used in several other circuits, refer to section
8W - 47 AUDIO SYSTEM
8W-12 for additional information on the IOD fuse.
The IOD fuse is removed during vehicle shipping to
prevent excessive battery draw.
The other circuit is the X60 circuit from the power
amplifier. This circuit is HOT when the radio is in
the ON position. Ground for the antenna is a case
ground.
CCD BUS
The CCD Bus is used on the premium system only.
It allows the radio to interface with the CCD bus.
Circuits D1 and D2 are used. The D1 circuit is the
CCD (+), and circuit D2 is the CCD(-).
HELPFUL INFORMATION
• Check for a blown 20 amp fuse in cavity 8 of the
junction block
• Check the 20 amp fuse located in cavity 8 of the
PDC
• Check the case ground attached to the rear of
the radio
• Check the 10 amp IOD fuse located in cavity 5
of the junction block
8W - 47 - 5