Starting System Test - Chrysler Stratus RHD 1997 Interactive Electronic Service Manual

JA
DIAGNOSIS AND TESTING (Continued)
(2) To disable the ignition and fuel systems, dis-
connect the Automatic Shutdown Relay (ASD) in the
Power Distribution Center (PDC). Refer to the PDC
cover for the proper relay location.
(3) Verify that:
• All lamps and accessories are OFF
• Automatic transmission shift selector is in PARK
• Manual transmission clutch pedal depressed
• Set parking brake
(4) Rotate and hold the ignition switch in the
START position. Observe the volt-ampere tester (Fig.
4).
• Voltage above 9.6 volts, and amperage draw
above 280 amps, check for engine seizing or faulty
starter.
• Voltage above 12.4 volts and amperage reads 0
to 10 amps, check for corroded cables and/or bad con-
nections.
• Voltage below 9.6 volts and amperage draw
above 300 amps, the problem is the starter. Replace
the starter refer to starter removal.
CAUTION: Do not overheat the starter motor or
draw the battery voltage below 9.6 volts during
cranking operations.
(5) After the starting system problems have been
corrected, verify the battery state-of-charge and
charge battery if necessary. Disconnect all testing
equipment and connect ASD relay. Start the vehicle
several times to assure the problem has been cor-
rected.

STARTING SYSTEM TEST

For circuit descriptions and diagrams, refer to
8W-21, Starting System in Group 8W, Wiring Dia-
grams.
WARNING: ON VEHICLES EQUIPPED WITH AIR-
BAGS, REFER TO
RESTRAINT SYSTEMS
STEERING WHEEL,
INSTRUMENT PANEL COMPONENT DIAGNOSIS OR
SERVICE. FAILURE TO TAKE THE PROPER PRE-
CAUTIONS COULD RESULT IN ACCIDENTAL AIR-
BAG DEPLOYMENT AND POSSIBLE PERSONAL
INJURY.
GROUP 8M - PASSIVE
BEFORE ATTEMPTING
STEERING COLUMN,
INSPECTION
Before removing any unit from the starting system
for repair or diagnosis, perform the following inspec-
tions:
• Battery - Visually inspect the battery for indi-
cations of physical damage and loose or corroded
cable connections. Determine the state-of-charge and
cranking capacity of the battery. Charge or replace
the battery, if required. Refer to Group 8A, Battery
for more information.
• Ignition Switch - Visually inspect the ignition
switch for indications of physical damage and loose
or corroded wire harness connections.
•
Clutch Pedal Position Switch - Visually
inspect the clutch pedal position switch for indica-
tions of physical damage and loose or corroded wire
harness connections.
•
Park/Neutral Position Switch - Visually
inspect the park/neutral position switch for indica-
tions of physical damage and loose or corroded wire
harness connections.
•
Starter Relay - Visually inspect the starter
relay for indications of physical damage and loose or
corroded wire harness connections.
• Starter - Visually inspect the starter for indi-
cations of physical damage and loose or corroded wire
harness connections.
• Starter Solenoid - Visually inspect the starter
solenoid for indications of physical damage and loose
or corroded wire harness connections.
• Wiring - Visually inspect the wire harness for
damage. Repair or replace any faulty wiring, as
required.
OR
STARTING 8B - 5