Door Lock System; Voltage; Removal And Installation; Door Lock Motor/Latch - Chrysler Stratus RHD 1997 Interactive Electronic Service Manual

JA
DIAGNOSIS AND TESTING (Continued)
Fig. 2 Door Lock Switch Continuity Test

DOOR LOCK SYSTEM

For complete testing of the automatic door lock
systems, refer to the proper Body Diagnostic Proce-
dures Manual.

VOLTAGE

The following circuit test sequence determines
whether or not voltage is continuous through the
body harness to switch.
(1) Remove the driver door trim panel. Refer to
Group 23, Body for proper procedures.
(2) Carefully separate multiple terminal block on
wiring harness from switch body. Refer to Group 8W,
Wiring Diagrams.
(3) Using a voltmeter, connect the ground lead to
the Pin 3 of the door lock connector.
(a) Using the positive lead, check Pin 1 of the
connector for battery voltage. If OK, go to Step 2. If
not OK, check fuse 5 in the Junction Block, if fuse
is OK, repair wire as necessary.
POWER DOOR LOCKS
(b) Check Pin 2 of the connector for battery volt-
age. If OK, go to Switch Test. If not OK, check fuse
4 in the Junction Block, if fuse is OK, repair wire
as necessary.

REMOVAL AND INSTALLATION

DOOR LOCK MOTOR/LATCH

REMOVAL
(1) Remove door trim panel, refer to Group 23
Body, for removal procedures.
(2) Disconnect motor/latch wire connector (Fig. 1).
(3) Disconnect linkage from:
• Outside door handle
• Inside door handle
• Locking knobs
• Key cylinder
(4) Remove motor/latch assembly attaching screws
and remove assembly.
INSTALLATION
For installation, reverse the above procedures.

DOOR LOCK SWITCH

REMOVAL
(1) Remove door trim panel, refer to Group 23
Body, for removal procedures.
(2) Disconnect switch wire connector.
(3) Remove switch attaching screws and remove.
INSTALLATION
For installation, reverse the above procedures.
8P - 3