Chrysler Stratus RHD 1997 Interactive Electronic Service Manual page 87

STEERING HEAT SHIELD KNUCKLE TIE END STUD ROD HEAT SHIELD TIE ROD END CROWFOOT
3 - 8 DIFFERENTIAL AND DRIVELINE
REMOVAL AND INSTALLATION (Continued)
(9) Install tie rod end into the steering knuckle.
Start tie rod end to steering knuckle nut onto stud of
tie rod end. While holding stud of tie rod end station-
ary (Fig. 19), tighten tie rod end to steering knuckle
nut. Using a crowfoot and 11/32 socket, tighten the
nut to 61 N·m (45 ft. lbs.) (Fig. 20).
Fig. 19 Installing Tie Rod End Nut
Fig. 20 Torquing Tie Rod End Nut
(10) Install braking disc back on hub and bearing
assembly.
11/32 SOCKET NUT STEERING KNUCKLE TORQUE WRENCH
TIE ROD END
CALIPER STEERING AWAY LIFT THIS END OF CALIPER ROTOR KNUCKLE GUIDE PIN BOLTS FROM ASSEMBLY KNUCKLE FIRST DISC BRAKE CALI- STEERING PER ASSEMBLY
(11) Install disc brake caliper assembly on steering
knuckle. Caliper is installed by first sliding top of
caliper under top abutment on steering knuckle.
Then installing bottom of caliper against bottom
abutment of steering knuckle (Fig. 21).
Fig. 21 Disc Brake Caliper Assembly Installation
(12) Install caliper assembly to steering knuckle
guide pin bolts (Fig. 22). Tighten caliper assembly
bolts to 31 N·m (23 ft. lbs.).
Fig. 22 Disc Brake Caliper Bolts
STEERING KNUCKLE DISC BRAKE CALI- PER ASSEMBLY BRAKE SHOE OUTBOARD
JA