Chrysler Stratus RHD 1997 Interactive Electronic Service Manual page 51

Table of Contents

Advertisement

BALL
UPPER
SEAL BOOT
JOINT
BOOT INSTALLATION SEC-
SEALING
RING
Wipe off the grease.
LIP
2 - 40
SUSPENSION
DISASSEMBLY AND ASSEMBLY (Continued)
(1) Apply grease from the ball joint seal kit, to the
specified areas of the ball joint stud and seal (Fig.
107). Be sure no grease is present on the seal boot
installation section of the seal boot or lower control
arm (Fig. 107).
Fig. 107 Grease Correctly Applied To BallJoint Stud
And Seal Boot
(2) Slide ball joint seal boot with upper seal ring
installed, (Fig. 107) down tapered section of ball joint
stud (Fig. 107). Seal boot is to be installed on stud of
ball joint until seal boot is sitting on seal groove in
lower control arm.
(3) Carefully position ball joint seal boot in seal
retaining groove on lower control arm. After install-
ing seal boot in retaining groove, carefully bleed air
out of sealing boot without getting grease pushed
into seal boot retaining groove in lower control arm.
(4) Place Retaining Ring Installer, Special Tool,
6875-1 over ball joint seal boot (Fig. 108). Using
adjusting knob, adjust tool so bottom edge of tool is
even with top of retaining ring groove in seal boot
(Fig. 108).
(5) Place seal boot retaining ring on Installer, Spe-
cial Tool, 6875- 1 (Fig. 109). Then place expandable
collar from Installer, Special Tool, 6875 over tapered
cone of the special tool (Fig. 109).
(6) Using the expandable collar of Installer, Spe-
cial Tool, 6875 (Fig. 110) push the seal boot retaining
ring down the cone of Installer, Special Tool, 6875.
TION
GREASE BALL JOINT STUD TAPERED
BOOT INSTALLATION SEC-
Wipe off the grease.
SECTION
TION
GREASE
RETAINING
SEAL
SEAL
MUST BE EVEN WITH TOP
BOTTOM EDGE OF TOOL
OF
GROOVE IN SEAL BOOT AS
LOWER
RETAINING
SPECIAL TOOL 6875-1
BOOT
GROOVE
BOOT
RING
CONTROL
Fig. 108 Correctly Installed Ball Joint SealRetaining
Fig. 109 Retaining Ring And Expandable
RETAINING
SHOWN
ARM
RING
RING
Ring Tool
CollarInstalled On Tool
LOWER CONTROL ARM
SPECIAL TOOL 6875
ADJUSTING KNOB
JA

Advertisement

Table of Contents
loading

This manual is also suitable for:

Stratus lhd 1997

Table of Contents