Chrysler Stratus RHD 1997 Interactive Electronic Service Manual page 692

JA
DESCRIPTION AND OPERATION
TRAVELER
Power for the traveler is supplied from two
sources. There is a constant battery feed on circuit
M1. This is the Ignition Off Draw (IOD) circuit and
is protected by a 10 amp fuse located in cavity 5 of
the junction block.
Power is also supplied to the traveler on circuit
F18. This circuit is HOT in the START and RUN
position and protected by a 10 amp fuse located in
cavity 9 of the Power Distribution Center (PDC).
Power for the fuse is supplied on circuit A21 from the
ignition switch.
Ground for the traveler is supplied on circuit Z1.
This circuit terminates at the instrument panel left
side cowl.
8W - 46 TRAVELER
8W-46 TRAVELER
The traveler is also interfaced with the CCD Bus.
This interface allows the traveler to receive the nec-
essary information for display to the operator. The
circuits involved are D1 for CCD (+), and D2 for CCD
(-).
HELPFUL INFORMATION
• Check the 10 amp IOD fuse in cavity 5 of the
junction block
• Check the 10 amp fuse located in cavity 9 of the
PDC
• Check the ground at the instrument panel left
side cowl
8W - 46 - 3