Camshaft Position Sensor-Dohc - Chrysler neon 1997 Service Manual

CAMSHAFT POSITION SEN- REAR OF CYLINDER HEAD REAR OF CYLINDER HEAD SOR
8D - 14 IGNITION SYSTEM
REMOVAL AND INSTALLATION (Continued)
Fig. 32 Camshaft Position Sensor Location—SOHC
Fig. 33 Target Magnet Removal/Installation
INSTALLATION
The target magnet has two locating dowels that fit
into machined locating holes in end of the camshaft.
(1) Install target magnet in end of camshaft.
Tighten mounting screw to 3.4 N·m (30 in. lbs.)
torque.
(2) Install camshaft position sensor. Tighten sensor
mounting screws to 9 N·m (80 in. lbs.) torque.
(3) Place brake booster hose and electrical harness
in holders on end of valve cover.
(4) Attach electrical connectors to coolant tempera-
ture sensor and camshaft position sensor.
(5) Install air cleaner inlet tube and filtered air
tube.
CAMSHAFT POSITION SENSOR—DOHC
The camshaft position sensor is mounted to the
rear of the cylinder head (Fig. 34).
REMOVAL
(1) Remove filtered air tube from the throttle body
and air cleaner housing.
TARGET MAGNET MOUNTING BOLT CAMSHAFT POSITION SEN- MOUNTINGBOLT SOR
Fig. 34 Camshaft Position Sensor Location—DOHC
(2) Disconnect electrical connector from camshaft
position sensor.
(3) Remove camshaft position sensor mounting
screws. Remove sensor.
(4) Loosen screw attaching target magnet to rear
of camshaft (Fig. 35).
Fig. 35 Target Magnet Removal/Installation
INSTALLATION
The target magnet has locating dowels that fit into
machined locating holes in the end of the camshaft
(Fig. 36).
(1) Install target magnet in end of camshaft.
Tighten mounting screw to 3 N·m (30 in. lbs.) torque.
(2) Install camshaft position sensor. Tighten sensor
mounting screws to 9 N·m (80 in. lbs.) torque.
(3) Carefully attach electrical connector to cam-
shaft position sensor. Installation at an angle may
damage the sensor pins.
(4) Install filtered air tube. Tighten clamps to 3
N·m 1 (25 in. lbs.
TARGET MAGNET
5) torque.
PL