Processors And Heat Sinks; Removing A Processor And Heat Sink Module - Dell EMC PowerEdge T440 Installation And Service Manual

Figure 69. Installing optional IDSDM/vFlash card
Next steps
1 Install the MicroSD cards.
NOTE: Reinstall the MicroSD cards into the same slots based on the labels you had marked on the cards during
removal.
2 Follow the procedure listed in

Processors and heat sinks

Removing a processor and heat sink module

Prerequisites
WARNING: The heat sink may be hot to touch for some time after the system is powered down. Allow the heat sink to cool
before removing it.
1 Follow the safety guidelines listed in
2 Follow the procedure listed in
3 Remove the air shroud.
Steps
1 Using a Torx #T30 screwdriver, loosen the screws on the heat sink in the order below:
a Loosen the first screw three turns.
b Loosen the second screw completely.
c Return to the first screw and loosen it completely.
2 Pushing both blue retention clips simultaneously, lift the processor and heat sink module (PHM) processor and heat sink module
After working inside your system.
Safety instructions.
Before working inside your system.
Installing and removing system components 121