Table of Contents
Advertisement
AT8402
2.3
Standard Removal Procedures
To remove the board proceed as follows:
1.
Ensure that the safety requirements indicated in section 2.1. are observed.
Warning!
Care must be taken when applying the procedures below to ensure that
neither the AT8402 nor system boards are physically damaged by the
application of these procedures.
2.
Unscrew the front panel retaining screws.
3.
Push in and hold the ejector handles in a horizontal position to release the hot swap
switch. The blue LED starts blinking.
4.
Wait until the blue LED is fully ON, this mean that the hot swap sequence is ready for
board removal.
5.
Disengage the board from the backplane by using both board ejection handles.
6.
After disengaging the board from the backplane, pull the board out of the slot.
2.4
AMC Installation
To install an AMC proceed as follows:
1.
Remove the AMC filler panel.
2.
Carefully engage the AMC into the card guide. Push the AMC until it fully mates with its
connector. Secure the AMC handle to the locking position.
3.
In normal condition, the blue LED shall turn ON as soon as the AMC is fully inserted. It
will turn OFF at the end of the hot swap sequence.
2.5
RTM Installation
To install the Kontron RTM8400 proceed as follows:
1.
Remove the RTM filler panel.
2.
Carefully insert the board into the RTM slot corresponding to the front board slot of the
AT8402 until it makes contact with the front board connectors.
3.
Connect all external interfacing cables to the RTM as required.
4.
Ensure that the RTM and all required interfacing cables are properly secured.
The features of the RTM8400 are described in detail in Chapter 3, section 3.2.
Page 2 - 4
Installation
AT8402 User Guide
Advertisement
Table of Contents
