Table of Contents
Advertisement
Installation
3.3
Standard Removal Procedures for the CP3002-RC
To remove the board proceed as follows:
1. Ensure that the safety requirements indicated in Chapter 3.1 are observed. Particular
attention must not only be paid to the warning regarding the heat sink, but the user must
also be aware that the surrounding system components and chassis can get very hot!
Warning!
Care must be taken when applying the procedures below to ensure that
neither the CP3002-RC nor system boards are physically damaged by the
application of these procedures.
2. Ensure that no power is applied to the system before proceeding.
3. Unfasten the ejector handle retaining screw.
4. Ensure that both the top and bottom wedge-locks are fully relaxed.
To relax the wedge-lock, turn the wedge-lock's screw counter-clockwise using a 2.5 mm
hex key until the screw is against the stop.
Warning!
Due care should be exercised when handling the board due to the fact that
the heat sink can get very hot - danger of burns. In addition, the surround-
ing system components and chassis may be very hot.
If required, use protective gloves to handle the CP3002-RC when remov-
ing it.
5. Disengage the board from the backplane using the ejector handle as required until the
board is disengaged from the backplane.
6. After disengaging the board from the backplane, pull the board out of the slot.
7. Ensure that the ejector handle retaining screw is properly fastened.
8. Dispose of the board as required.
Page 3 - 6
CP3002-RC/CP3002-RA
ID 1039-3625, Rev. 1.0
Advertisement
Table of Contents
