Table of Contents
Advertisement
All manuals and user guides at all-guides.com
Installing the Switch On a Table or Desktop
To install the switch on a table or desktop, perform the following procedure:
1.
Remove all components from the shipping package and store the
packaging material in a safe location.
2.
Locate a level, secure surface for the switch.
Note
If desired, you can affix the switch to a flat surface using the two
threaded screw holes on the bottom of the chassis. The holes use M4
screws (not provided) and are 100 millimeters (3.94 inches) apart.
3.
Power ON the switch using the external power adapter supplied with the
unit. Connect the external power adapter to an appropriate power source
and the DC cable on the adapter to the DC connector on the switch.
The PWR LED on the switch's front panel should be ON. If the LED
remains OFF, refer to "Verifying and Troubleshooting the Installation" on
page 22 for assistance.
Warning
The power cord is used as a disconnection device. To de-energize
equipment, disconnect the power cord.
Note
To prevent the DC power cable from being inadvertently pulled out of
the switch, use the cable tie supplied with the unit to secure the DC
power cable to the small cable hook located next to the DC connector.
4.
Connect the twisted pair cables to the RJ45 connectors on the switch.
5.
Remove the dust cover from the fiber optic port and connect the fiber optic
cable to the port.
6.
Set the 100FX DUPLEX switch to either HALF for half-duplex or FULL
for full-duplex operation. The capabilities of the end node connected to the
fiber optic port will determine the correct setting for this switch. If the end
node is capable of only half-duplex, set the switch to HALF. If the end node
is capable of full-duplex, set the switch to FULL.
20
9
Advertisement
Table of Contents
