Replacing Sd Card - Epson VT Series Manipulator Manual

Maintenance 18. Controller Unit

18.6 Replacing SD Card

Maintenance
parts
Tools
NOTE

SD Card (1) Turn OFF the Manipulator.
Removal
(2) Remove the power plug.
(3) Remove the optional slot cover.
(4) Push the SD card which is inserted near the
SD Card
(1) Push the SD card and inset to the SD card slot near the optional slot.
Installation
(2) Mount the optional slot cover.
240
Name
SD Card
Cross-point screwdriver (No. 2)
Remove the SD card after removing the fieldbus I/O module if fieldbus I/O module is
inserted to the optional slot. Also, install fieldbus I/O module after installing the SD
card.
For more details about fieldbus I/O module, refer to the following.
Setup & Operation 17: Fieldbus I/O.
Pan head screws: 2-M3×6 Sems
optional slot to eject.
Pan head screws: 2-M3×6 Sems
Tightening torque: 0.45 ± 0.1N·m
Quantity
1 2182748
1
Optional slot cover
Note
VT Rev.1