Table of Contents
Advertisement
9.2 Joint #5 - Replacing the Reduction Gear Unit
(Replacing the Joint #5, #6 Reduction Gear Unit Set)
For replacement of the Joint #5 and Joint #6 reduction gear unit, replace the Joints #5, #6 reduction gear unit set.
The Joints #5 and #6 reduction gear unit set is adjusted in advance.
Maintenance
Joints #5, #6 Reduction gear unit set
Parts
Belt tensile jig*
Hexagonal
wrench
Tools
Cross-point screwdriver (#2)
Torque wrench
Spanner ( width across flats: 8 mm)
Feeler gauge (0.5 mm)
Belt tension meter
The brake is mounted on each joint to prevent the arm from lowering due to its own weight while the Controller
power is OFF or the motor is OFF status. The brake does not work during replacement. Be careful when
performing maintenance work.
C8 Rev.13
Name
width across flats: 2 mm
width across flats: 2.5 mm
width across flats: 3 mm
width across flats: 4 mm
width across flats: 5 mm
Maintenance 9. Joint #5
Qty.
1
1674610 (common to C8 series)
1
1674582
1
For M4 hexagon socket set screws
1
For M3 hexagon socket head cap bolts
1
For M4 hexagon socket head cap bolts
1
For M5 hexagon socket head cap bolts
1
For M6 hexagon socket head cap bolts
1
For cross recessed head screws
1
For tightening torque control
1
For air fittings
2
For drive boss position adjustment
1
Refer: Unitta U-505
Note
281
Advertisement
Table of Contents
