Operating The Simulation - HEIDENHAIN TNC 640 User Manual

Operating the Touchscreen | Gestures

Operating the simulation

The control offers touch operation with the following graphics:
Programming graphics in the Programming mode of operation
3-D view in the Test Run operating mode
3-D view in the Program Run Single Block operating mode
3-D view in the Program Run Full Sequence operating mode
Kinematics view
Rotate, zoom or move a graphic
The control supports the following gestures:
Symbol Gesture
Double tap
Drag
Two-finger drag
Spread
Pinch
HEIDENHAIN | TNC 640 | Conversational Programming User's Manual | 10/2017
Function
Set the graphic to its original size
Rotate the graphic (only 3-D graphics)
Move graphics
Magnify the graphic
Reduce the graphic
3
135