Mod Function - HEIDENHAIN ITNC 530 - PILOT SMART NC Manual

MOD function

The MOD functions provide additional input possibilities and displays.
Selecting the MOD functions
U Press the MOD key for the TNC to display the possible
settings in the smarT.NC operating mode
Changing the settings
U
Select the desired MOD function in the displayed menu with the arrow
keys
There are three possibilities for changing a setting, depending on the
function selected:
Enter a numerical value directly, e.g. when determining the traverse
range limit
Change a setting by pressing the ENT key, e.g. when setting program
input
Change a setting via a selection window. If more than one possibility is
available for a particular setting, you can superimpose a window listing
all of the given possibilities by pressing the GOTO key. Select the
desired setting directly by pressing the corresponding numerical key
(to the left of the colon), or by using the arrow keys and then confirming
with ENT. If you don't want to change the setting, close the window
again with END
Exiting the MOD functions
U To exit the MOD functions, press the END key or END soft key
44