NOTE
Figure 3-15
NOTE
Changing sweep frequencies (and other source parameters) may affect
your calibration. See
Connect the DUT
Equipment Setup for a Reflection Measurement of a Two-Port
Device
If you connect the DUT between both analyzer ports, it is recommended
that you use a 10 dB pad on the output of the DUT to improve
measurement accuracy. If you connect a two-port DUT to the
REFLECTION port only, it is recommended that you use a high-quality
load (such as a calibration standard) on the output of the DUT.
ET User's Guide
Chapter 6
for more information.
Making Measurements
Measuring Reflection Response
3-35