HP 8712ET User Manual page 378

Stop Power
Store CC
To Disk
Store CC
To EPROM
Subnet Mask
SWEEP
Sweep Out
Hardkey/Softkey Reference
S
Softkey in the POWER
power sweep measurement.
be selected before setting the start and stop power points.
See the Power Sweep
the power sweep function.
Softkey in the update correction constants menu. Writes a copy of CC
data from internal volatile RAM to a 3.5" disk in the analyzer's built-in
disk drive. This function is used to make a backup copy of CC data.
See the Service Guide for more information.
Access Keys:
SYSTEM OPTIONS
Softkey in the update correction constants menu. Writes a copy of CC
data from internal volatile RAM to EPROM. This function is used so
that current CC data is not lost when power to the analyzer is turned
off.
See the Service Guide for more information.
Access Keys: SYSTEM OPTIONS
Softkey in the LAN port setup menu. Allows you to enter the numbers
that your network administrator assigned to your analyzer. If you were
not assigned a subnet mask, leave the setting at 0.0.0.0 (default value)
to disable subnet masking.
See The LAN Interface User's Guide Supplement for more information.
Access Keys:
SYSTEM OPTIONS
Hardkey in the SOURCE area of the front panel. Displays the menu to
select automatic sweep time (fastest possible), manual sweep,
alternate sweep, or power sweep.
Softkey in the user TTL config menu. Sets the USER TTL IN/OUT port
on the rear panel to be pulled to a high TTL level during a sweep.
See Figure 7-2, "Analyzer Connectors—Rear Panel BNC Connectors,"
on page 7-2 for more information.
Access Keys:
SYSTEM OPTIONS
User TTL Config
8-86
menu. Sets stopping point (in dBm) for a
Power Sweep
entry in this chapter for more information on
Service
Service
LAN LAN Port Setup
System Config
in SWEEP menu must
Update Corr Const
Update Corr Const
ET User's Guide