Remove Pattern
Rename File
Response
Response
& Isolation
Restart Average
Softkey in the CRT adjust menu. A test pattern is displayed whenever
the
CRT Adjust
key is pressed. Use this key to remove the test
pattern from the display.
Access Keys:
SYSTEM OPTIONS
Softkey in the file utilities menu. Displays the character entry menu to
rename the highlighted file.
See
"Other File Utilities" on page 4-63
Access Keys:
SAVE RECALL
Softkey in the
CAL
key to perform a user-defined response calibration. Restores a previous
response calibration if current analyzer parameters are compatible
with those used during the previous calibration. Corrects for frequency
response errors.
See
Chapter 6
for more information.
Softkey in the
CAL
key to perform a user-defined response & isolation calibration.
Restores a previous response & isolation calibration if current analyzer
parameters are compatible with those used during the previous
calibration. Corrects for frequency response and isolation errors.
Isolation errors result from leakage between signal paths (crosstalk).
See
Chapter 6
for more information.
Softkey in the
AVG
with the next sweep.
See
"To Reduce the Receiver Noise Floor" on page 5-10
on averaging.
ET User's Guide
System Config
for more information.
File Utilities
menu when measuring transmission. Select this
menu when measuring transmission. Select this
menu. Clears the running average and restarts it
Hardkey/Softkey Reference
CRT Adjust
for information
8-73
R