HP 8712ET User Manual page 376

Spur Avoid
Spur Avoid
Options
SRL
Stack Size
Start
Hardkey/Softkey Reference
S
Softkey in the spur avoid options menu. If this option is selected, the
analyzer switches between the default and an alternate configuration
during a sweep to avoid spurs.
NOTE
See "Reducing Trace Noise" on page 5-12
CAUTION
Access Keys:
MENU
Softkey in the source
dither, spur avoid, or none.
(Option 100 only) Softkey in the cable or measurement menus. Selects
the structural return loss (SRL) measurement. See your Option 100
User's Guide Supplement for information.
Access Keys:
BEGIN
Softkey in the utilities menu. Allows you to set the number of bytes in
the stack size by using the analyzer's numeric keypad.
Access Keys:
SYSTEM OPTIONS
Softkey in two menus:
1. In FREQ menu, sets the start frequency of the source. Minimum
frequency is 300 kHz. When start is selected, the other frequency
parameter that must be defined is stop.
See "Entering Measurement Parameters" on page 2-4
information.
2. In
HARDCOPY
port menu.
See "Printing and Plotting Measurement Results" on page 4-77
more information.
8-84
Sweeptime usually increases when this option is
selected.
The measurement calibration must be performed
with the same spur avoid option used in the
measurement or your results may be invalid.
Spur Avoid Options
. Displays selections for spur avoidance:
MENU
Cable or
MEAS 1
IBASIC
and
FREQ HARDCOPY
menu, starts print or plot as set in the select copy
for more information.
or
MEAS 2
Utilities
.
for more
ET User's Guide
for