Make A Broadband Power Measurement - HP 8712ET User Manual

NOTE
Figure 2-8

Make a Broadband Power Measurement

1. Leave the cable connected to the analyzer as shown in
The quality of the cable will affect these measurements; make sure you
use a cable with the characteristics described in
page 2-10.
2. Press
MEAS 1
Enter .
1
3. Press POWER
measurement).
4. Verify that the data trace is within ±2 dB of 0 dBm. See
a typical HP 8714ET result. The HP 8712ET should look similar, but
end at 1300 MHz.
Verify Broadband Power Measurement
ET User's Guide
Power FREQ Start
0 dBm (unless done in the previous
Getting Started
Performing the Operator's Check
Figure
"Equipment List" on
MHz
10 SCALE
Figure 2-8
2-6.
for
2-13