HP 8712ET User Manual page 220

Rf network analyzers

Hide thumbs Also See for HP 8712ET:

Table of Contents

Optimizing Measurements

Reducing Trace Noise

To activate spur avoidance:

2. Make a user-deﬁned measurement calibration. For calibration

procedures, refer to

Using spur avoid increases sweep time. Since there are more spurs at the

lower frequencies, the time penalty can be reduced by setting the start

frequency of the measurement as high as possible.

The measurement calibration must be performed with the same spur

avoid mode used in the measurement or your results may be invalid.

You will invalidate the measurement calibration if you turn spur avoid

Spur Avoid Options

ET User's Guide