HP 8712ET User Manual page 313

Default
Default 1-Port
Default 2
Define Graph
Define
Hardcopy
Softkey in the user TTL config menu. Pressing this softkey configures
the rear panel USER TTL IN/OUT connector for general purpose I/O
use with IBASIC and SPCI commands. This connector can also be
configured for softkey sequencing using an external switch, and as a
sweep out connector.
See "User-Defined TTL Input/Output" in the Automating
Measurements User's Guide Supplement, and
for more information.
Access Keys:
SYSTEM OPTIONS
User TTL Config
Softkey in the
CAL
recall a one-port calibration that was performed at the factory or
during servicing. Corrects for directivity, source match, and frequency
response errors.
See Chapter 6 for more information on calibrating the analyzer.
Softkey in the color options menu. Sets the external VGA monitor
colors to the Default 2 setting.
See "Using an External VGA Monitor" on page 4-86
information.
Access Keys:
DISPLAY
Softkey in the define hardcopy menu. Displays the menu to define
which parts of the graph are to be printed or plotted: trace data,
graticule, annotation, marker symbol, title and clock, or combinations.
See "Printing and Plotting Measurement Results" on page
Access Keys:
HARDCOPY
Softkey in the
HARDCOPY
hardcopy in terms of information to be copied. Default setting is
Graph Only
See "Printing and Plotting Measurement Results" on page
ET User's Guide
System Config
menu when measuring reflection. Use this key to
More Display Color Options
Define Hardcopy
menu. Displays the menu to define the
Hardkey/Softkey Reference
Figure 7-2 on page 7-4
for more
4-77.
4-77.
D
8-21