HP 8712ET User Manual page 99

Figure 3-22 Through-Cable Connection
2. Set the following frequency parameters:
3. Press
4. Insert the mixer as shown in
5. Press
ET User's Guide
FREQ
Center 700
Span 15 MHz
This sets the analyzer frequency range to sweep over the passband of
the IF filter (700 MHz).
Normalize
DISPLAY
This stores the filter response passband into memory, and sets up a
normalized trace so that the filter response magnitude is removed
from the measurement.
Center
FREQ
frequency so that the mixing product of the mixer is in the passband
of the IF filter.
MHz
or
CAL
Figure 3-23.
MHz to change the center
900
Making Measurements
Measuring Conversion Loss
Normalize on OFF .
3-47