HP 8712ET User Manual page 389

Vertical
Position
View Cal Check
Volatile
RAM Disk
Softkey in the CRT adjust menu. Changes the vertical positioning of
the display on both the internal CRT and an external monitor. Accepts
whole number values from 1 to 100, with 1 representing as far up as
possible and with 100 representing as far down as possible. The default
value set at the factory (and obtained by pressing ) is 74. This setting is
not affected by an instrument preset.
See "Using an External VGA Monitor" on page 4-86
information.
Access Keys:
SYSTEM OPTIONS
Softkey in the cal check menu. After a cal check has been performed,
this key will allow you to display the corrected measurement
uncertainties that apply to the current instrument settings and
calibrations.
See Chapter 6 for more information on using cal check.
Access Keys:
CAL
Softkey in the select disk menu. Selects the analyzer's internal volatile
RAM as the place where information will be saved to or recalled from.
CAUTION
See "Saving and Recalling Measurement Results" on page 4-55
more information.
Access Keys:
SAVE RECALL
ET User's Guide
System Config
Cal Check
Any information stored on the volatile RAM disk
will be lost if the analyzer's power is turned off.
Select Disk
Hardkey/Softkey Reference
for more
CRT Adjust
for
8-97
V