HP 8712ET User Manual page 39

Presetting the
Analyzer
NOTE
NOTE
Press the
PRESET
Factory Preset . The
user-defined preset settings you may have saved as file UPRESET.STA.
If this file doesn't exist, you can create it by following the instructions in
the pop-up message that appears when the key is pressed. When the
Factory Preset key is pressed, the following major default conditions
apply:
Frequency range (HP 8712ET)
Frequency range (HP 8714ET)
1
Power level
Measurement Channel 1
measurement
Measurement Channel 2
measurement
Format
Number of points
Sweep time
Scale
Reference
System Bandwidth
1. Preset power level can be set to other than 0 dBm if desired.
See "Entering Source Power Level" on page 2-6
information.
The measurement parameters that you enter will be retained in the
analyzer's memory when the power is turned off, and will be restored
when the power is turned back on.
Refer to Chapter 11, "Factory Preset State and Memory Allocation,"
comprehensive table of factory preset conditions.
ET User's Guide
key and then press either
User Preset key returns the analyzer to
0.3 to 1300 MHz
0.3 to 3000 MHz
0 dBm
Transmission
Off
Log Magnitude
201
Auto
10 dB/div
0 dB
Medium wide
Getting Started
Entering Measurement Parameters
User Preset
for more
or
for a
2-5