Installing The Switch - Allied Telesis GS950PS V2 Series Quick Installation Manual

The site should allow for adequate air flow around the unit and

through the cooling vents on the side panels.
Do not place objects on top of the switch.

The site should not expose the switch to moisture or water.

The site should be a dust-free environment.

The site should use dedicated power circuits or power

conditioners to supply reliable electrical power to the network
devices.
Do not install the switch in a wiring or utility box without adequate

airflow and cooling. The switch might overheat and shutdown.
Warning: Switches should not be stacked on a table or
desktop. They could present a physical safety hazard if
you need to move or replace switches.
Direction of Ventilation in the Switches
The GS950/18PS V2, GS950/28PS V2, and GS950/52PS V2
Switches have internal ventilation fans. Airflow is from left to right,
when facing the front of the switch.
Note: The GS950/10PS V2 Switch does not have ventilation fans.
The site must provide sufficient airflow to prevent overheating of the
device.

Installing the Switch

Installing the Switch on a Desk or Table
To install the switch on a desk or table, perform the following
procedure:
1. Place the switch upside down on the table.
2. Affix the bumper feet to the four corners on the bottom panel of
the switch.
8 GS950PS V2 Series Quick Installation Guide
 E91