Bluetooth® Module - Welch Allyn Connex Spot Monitor Directions For Use Manual

Directions for use
Agency approvals
Protocols
Data transfer
protocols
Output power
Ancillary IEEE
standards
1
One time passwords are not supported.
To ensure compliance with local regulations, be sure the correct country in which the
access point is installed is selected. This product can be used with the following
restriction(s):
Norway - Does not apply for the geographical area within a radius of 20 km from the
center of Ny-Ålesund.
France - Outdoor use is limited to 10 mW EIRP within the band 2454 to 2483.5 MHz.
Note
Note
®
Bluetooth module
Category
Wireless
specification
Host interface
802.11n (OFDM,HT20,MCS 0-7): 6.5,13,19.5, 26, 39,52, 58.5, 72.2 Mbps
US: FCC Part 15.247 Subpart C, FCC Part 15.407 Subpart E
Europe: Radio Equipment Directive 2014/53/EU
Canada: (IC) RSS-210 standard. IC 3147A-WB45NBT for Wi-Fi devices, IC 3147A-BT800 for
Bluetooth devices
Singapore: Model BT800. Manufactured by Laird, complies with IDS standards
UDP, DHCP, TCP/IP
UDP/TCP/IP
39.81mW typical, country-dependent
802.11d, 802.11e, 802.11h, 802.11i, 802.1X
Effective Isotropic Radiated Power (EIRP).
Some countries restrict the use of 5-GHz bands. The 802.11a radio in the
monitor uses only the channels indicated by the access point with which
the radio associates. The hospital IT department must configure access
points to operate with approved domains.
Feature
Bluetooth
Frequency
Maximum transmit power
Receive sensitivity
Range
Data rates
USB
Implementation
2.1 + EDR
2.402 - 2.480 GHz
Class 1
+8 dBm from antenna
-89 dBm
Circa 100 meters
Up to 3 Mbps (over the air)
Full speed USB 2.0
Specifications 139