Welch Allyn Connex Spot Monitor Directions For Use Manual page 118

112 Troubleshooting
Message
Temperature not functional.
03CA00
Temperature not functional.
03CB00
Temperature not functional.
03CC00
Temperature not functional.
03CD00
Temperature not functional.
03CE00
Temperature not functional.
03CE01
Direct mode reading timed out
Tissue contact lost.
Temperature module reset.
03D000
Braun 6000 messages
Message
Temperature not functional.
3F0105
Temperature not functional.
3F0201
Temperature not functional.
3F0202
Temperature not functional.
3F0203
Possible cause Suggested action
Unsupported message Internal malfunction. If the problem
received from the persists, replace the module.
Temperature module
Unable to send Internal malfunction. If the problem
message to the persists, replace the module.
Temperature module
Temperature module Internal malfunction. If the problem
communication times persists, replace the module.
out
Failed to upgrade the Internal malfunction. If the problem
temperature module persists, replace the module.
Unable to read PIM file Retry the device update.
Upgrade file directory Retry the device update
could not be accessed
Direct mode reading Direction mode reading times out
times out
Lost tissue contact Check the tissue contact and try the
while attempting to measurement again.
acquire a temperature
measurement or
acquired measurement
was performed with
limited tissue contact.
Temperature sensor None
reset unexpectedly
Possible cause Suggested action
WACP message CRC Internal malfunction. If the problem
mismatch. persists, replace the module.
This message is not Internal malfunction. If the problem
implemented by the persists, replace the module.
module.
This message is not Internal malfunction. If the problem
supported by the persists, replace the module.
module.
The module has run out Internal malfunction. If the problem
of memory. persists, replace the module.
®
Connex Spot Monitor
Alarm priority
Very low
Very low
Very low
Very low
Very low
Very low
Information
Information
Very low
Alarm
priority
Very low
Very low
Very low
Very low