Welch Allyn Connex Spot Monitor Directions For Use Manual page 35

Directions for use
•
•
4. Touch one of the options.
The monitor will either sign you out as a clinician so that another clinician can sign in,
power down, go into Sleep mode, or return to the prior screen, depending on the
option you choose. The battery continues to charge when in Sleep mode.
Reset the monitor
1. If the monitor stops functioning, press and hold
of the monitor, to reset the monitor.
2. If there is a prompt with options to power down, Sleep, or Cancel, continue to press
.
The monitor performs a power reset.
Sleep mode
After a configurable amount of time, the monitor enters sleep mode. Different types of
inactivity have different time delays.
• When a configurable amount of time has passed since the last screen press
• The sensor modules are not being used to capture vitals
• If the monitor does not have an active alarm
The monitor does not enter sleep mode when it is in Intervals monitoring.
Three situations cause the monitor to leave sleep mode.
• The power button is pressed.
• The screen is tapped.
• An alarm occurs.
Enter Sleep mode
1. Press
2. If there is no system message, a dialog box appears with options.
•
•
•
•
3. Touch Sleep.
The monitor enters Sleep mode.
Sleep
Cancel
CAUTION Do not use a long press of
it is functioning normally. You will lose patient data and configuration
settings. See "Power down the monitor" to power down the monitor.
.
Sign out (if you signed in with a Clinician ID)
Power down
Sleep
Cancel
, located on the lower-left corner
to power down the monitor when
Startup 29