System Messages - Welch Allyn Connex Spot Monitor Directions For Use Manual

Directions for use
Message
Unable to establish
network
communications.
1A0009
No connection for send. No connection for send.
Send not successful.
Error in record. Try again Connectivity NACK recieved for
Send successful.

System messages

Message
000001
000002
000003
000004
000005
000006
Internal hardware
failure.
Internal hardware
failure. 140100
Internal hardware
failure.
Internal hardware
failure. 1C1000
Low battery 30 minutes
or less remaining.
1C1005
Possible cause
No network connection is
available
Send not successful.
NRS/ECS/CS/NCE
Data was successfuly sent over
USB/BT
Possible cause
System failure
System failure
System failure
System failure
System failure
System failure
The root file system is corrupted;
restart not possible
EEPROM access failed. The device
boot is possible, but wired
communications are disabled
SPL memory test failure, the
monitor will sound an SOS pattern
The monitor PIC communications
never starts or quits. The
communication won't reasonably
recover at startup or during
operation
The battery power is low
Suggested action
Connect the device to an active network so
that the clinician ID can be imported.
None
None
NRS/ECS/CS/NCE NACK that is record
specific and can be fixed by a clinician in the
next record
None
Suggested action
Restart the monitor
Restart the monitor
Restart the monitor
Restart the monitor
Restart the monitor
Restart the monitor
Restart the monitor. If the problem persists,
replace the main PCBA.
Reprogram the EEPROM. If the problem
persists replace the main PCBA.
Restart the monitor. If the problem persists,
replace the main PCBA.
Restart the monitor. If the problem persists,
replace the main PCBA.
Connect the power supply to AC power to
charge the monitor.
Troubleshooting 123
Alarm
priority
Very low
Information
Information
Information
Information
Alarm
priority
N/A
N/A
N/A
N/A
N/A
N/A
N/A
Very low
N/A
N/A
Very low