Welch Allyn Connex Spot Monitor Directions For Use Manual page 16

Hide thumbs Also See for Connex Spot Monitor:
Table of Contents

Advertisement

10 About warnings and cautions
WARNING Liquids can damage electronics inside the monitor. Prevent
liquids from spilling on the monitor.
If liquids are spilled on the monitor:
1. Power down the monitor.
2. Disconnect the power plug.
3. Remove battery pack from the monitor.
4. Dry off excess liquid from the monitor.
If liquids possibly entered the monitor, remove the monitor
Note
from use until it has been properly dried, inspected, and
tested by qualified service personnel.
5. Reinstall battery pack.
6. Reconnect the power plug.
7. Power on the monitor and verify that the monitor functions normally before
using it.
WARNING The monitor may not function properly if dropped or damaged.
Protect it from severe impact and shock. Do not use the monitor if you
notice any signs of damage. Qualified service personnel must check any
monitor that is dropped or damaged for proper operation before putting the
monitor back into use.
WARNING Defective batteries can damage the monitor. If the battery
shows any signs of damage or cracking, it must be replaced immediately
and only with a battery approved by Welch Allyn.
WARNING Personal injury risk. Improper handling of the battery can lead
to heat generation, smoke, explosion or fire. Do not short-circuit, crush,
incinerate, or disassemble the battery. Never dispose of batteries in refuse
containers. Always recycle batteries according to national or local
regulations.
WARNING Use only Welch Allyn approved accessories, and use them
according to the manufacturer's directions for use. Using unapproved
accessories with the monitor can affect patient and operator safety and can
compromise product performance and accuracy, and void the product
warranty.
WARNING Wall mounted equipment and accessories must be installed in
accordance with accompanying instructions. Welch Allyn is not responsible
for the integrity of any installation not performed by authorized Welch Allyn
service personnel. Contact an authorized Welch Allyn service
representative or other qualified service personnel to ensure professional
installation for safety and reliability of any mounting accessory.
WARNING Welch Allyn is not responsible for the integrity of a facility's
power. If the integrity of a facility's power or protective earth conductor is
in doubt, always operate the monitor on battery power alone when it is
attached to a patient.
CAUTION Electric shock hazard. Do not sterilize the monitor. Sterilizing
the monitor could damage the device.
®
Connex
Spot Monitor

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents