Welch Allyn Connex Spot Monitor Directions For Use Manual page 17

Directions for use About warnings and cautions 11
CAUTION United States Federal law restricts this monitor to sale,
distribution, or use by or on the order of a physician or licensed healthcare
professional.
CAUTION Electromagnetic interference risk. The monitor complies with
applicable domestic and international standards for electromagnetic
interference. These standards are intended to minimize medical equipment
electromagnetic interference. Although this monitor is not expected to
present problems to other compliant equipment or be affected by other
compliant devices, interference issues still may occur. As a precaution,
avoid using the monitor in close proximity to other equipment. In the event
that equipment interference is observed, relocate the equipment as
necessary or consult manufacturer's directions for use.
CAUTION Do not move the stand while the power source is plugged into
the mains outlet.
CAUTION Do not sterilize the monitor. Sterilizing the monitor could harm
the device.
CAUTION Use only a Class I (grounded) AC power cord to charge the
power source for the monitor.
CAUTION Do not use a long press of to power down the monitor when
it is functioning normally. You will lose patient data and configuration
settings.
CAUTION Never move the monitor or mobile stand by pulling on any of
the cords. This may cause the monitor to tip over or damage the cord.
Never pull on the power cord when disconnecting the cord from the mains
outlet. When disconnecting the power cord, always grasp the attachment
plug. Keep the cord away from liquids, heat, and sharp edges. Replace the
power cord if the strain relief, cord insulation, or metal prongs are damaged
or begin to separate from the attachment plug.
CAUTION Use only the Welch Allyn USB client cable to connect a laptop
computer to the USB client port. Any laptop connected to the monitor must
be running on a battery, a 60601-1 compliant power supply, or a 60601-1
compliant isolation transformer.
CAUTION If the touchscreen is not responding properly, refer to the
troubleshooting section. If the problem cannot be resolved, discontinue use
of the monitor and contact an authorized Welch Allyn service center or
qualified service personnel.