Changing The Parameter; Changing The Network Configuration - Mitsubishi NZ2GF2B-60DA4 User Manual

7.2

Changing the Parameter

7.2.1

Changing the network configuration

When changing the network configuration diverting the created project, set the parameter in the following procedure.
1.
Power off the module.
2.
Connect the modules again according to the desired network configuration.
3.
Power on the module.
4.
Display the "CC IE Field Configuration" window.
• When the master/local module is the QJ71GF11-T2
Project window
[Ethernet/CC IE/MELSECNET]
• When the master/local module is the LJ71GF11-T2
Project window
5.
Drag and drop a module to set the slave station. Input a numerical value to set the station number
of the station. Change the value as necessary.
6.
Close the "CC IE Field Configuration" window.
[CC IE Field Configuration]
7.
Click the
68
[Parameter] [Network Parameter]
[Parameter] [Network Parameter]
button
[Close with Reflecting the Setting]
button to display the refresh parameter setting window.
button
[CC IE Field]