Mitsubishi NZ2GF2B-60DA4 User Manual page 153

(19)Module operation information initialization command (address: 1004
This command is used to clear the module operation information stored in the nonvolatile memory.
The module operation information can be initialized only when Nonvolatile memory data error (module operation
information) (error code: 0110
b15 b14 b13 b12 b11 b10 b9 b8
0 0 0
(a) Initializing the module operation information
The module operation information is initialized when the value in this area is set to Commanded (1).
Error data of module operation
Module operation information
initialization command
(address: 1004
Module operation information
initialization completed
(address: 1005
(b) Default value
The default value is set to Not commanded (0).
(20)Module operation information initialization completed (address: 1005
The initialization status of the module operation information stored in a nonvolatile memory is stored.
b15 b14 b13 b12 b11 b10 b9 b8
0 0
(a) Initializing the module operation information
When initialization of the module operation information is completed, the value in this area changes to
Completed (1). For the on and off timing, refer to the following.
• Module operation information initialization command (address: 1004
(b) Default value
The default value is set to Not performed (0).
) has occurred.
H
b7 b6 b5 b4 b3
0 0 0 0 0 0
Data for b1 to b15 are fixed to "0".
Controlled by the D/A converter module
Controlled by the program
Module operation
information
Not
Commanded (1)
commanded (0)
)
H
Not performed (0)
)
H
b7 b6 b5 b4 b3
0 0 0 0 0 0 0
Data for b1 to b15 are fixed to "0".
b2 b1 b0
0 0 0 0 0 0
0: Not commanded
1: Commanded
Default value
Not
commanded (0)
Completed
(1) performed (0)
b2 b1 b0
0 0 0 0 0 0
0: Not performed
1: Completed
) (
H
APPENDICES
)
H
Not
)
H
Page 151, Appendix 3 (19))
151
A